Forum Megane RS

arno samimi a écrit:RSC Competition Pro Öhlins Upgrade Kit inside!

Hi Arno, very good kit, thanks!

you welcome... have fun with it!

Development RSC Competition Pro Renault Clio V6 / PCB1A-RS: Camber plate rear axle

Front & rear steel brackets Clio V6 are back from black anodizing:

Spark Models now offers this year's racing car from the Porsche Carrera Cup Japan (PCCJ) sponsored by RSC Suspensions:

RSC Competition Pro Renault Sport Mégane 3 R.S. PDZ1N-TR3 (Trophy Special) grey/red:

Again some RSC kits for four different countries:
1x RSC Competition Light Öhlins Upgrade Kit LDZVT-OEH Mégane 3 R.S. -> F
2x RSC Competition Pro Öhlins Upgrade Kit PDZVT-OEH Mégane 3 R.S. -> D & UK
1x RSC Competiton Pro PDZ1N-RS (grey/yellow) Mégane 3 R.S. -> D
1x RSC Competiton Pro PDZ1N-TR3 (grey/red) Mégane 3 R.S. -> CH
RSC Suspensions wishes its customers a lot of fun with these!
-> www.rscenter.ch

7.46.46 BTG with RSC Competition Pro PSL5F-BB Seat Leon 3 Cupra 290

New RSC Suspensions aluminium parts back from anodizing:

Development soon finished: RSC Competition Pro PCB1A-RSC Renault Sport Clio V6:

RSC Porsche Supercup Sponsoring 2017:

Julian from D (Renault Mégane 3 R.S. Ph3 Trophy, by Email, 21.10.2017):

Ok, then I give here now also my Feedback. I myself drive a Renault Mégane 3 R.S. Ph3 Trophy, which is now used more than Tracktool. Since I have installed the RSC Competition Pro in April 2017 with some further changes in the Autohaus Fahrbach in Bad Mergentheim (Germany), I have been able to test it in a long and versatile way. The first trackday on the Nordschleife was then already in April, and I had a cozy journey with the setting “7 clicks open” (= in the direction of soft) of max. 12 clicks. Already on the Highway, I noticed how the RSC Competition Pro coilover works much better with ground waves and edges (transverse grooves) than the original Cup suspension. In corners, such as a motorway exit, you notice much stronger side forces because of -2.5 degrees camber at the front axle and -2 degrees camber at the rear axle. Then at the racetrack, I adjust the RSC Competition Pro within 2 minutes on “2 clicks open” at the front axle and “3 clicks open” at the rear axle of max. 12 clicks. After 4-5 laps I had full confidence in the RSC Competition Pro and the new Set Up. I could instantly drive 15-20 seconds faster than before with the Cup suspension. The car goes more jagged and much faster around the corners, and in long corners it pulls the Mégane more inside than before with the Cup suspension. After other everyday tests I can’t fault anything. The RSC Competition Pro runs perfectly, is very stable and quiet when braking. On the race track of Anneau du Rhin (F) I drove the RSC Competition Pro completely closed (0 clicks open = max hard) to front axle and rear axle. It worked perfectly on the race track. With some modifications, such as the ATS GTR, Yokohama AD08R, brake cooling, Recaro Pole position seat etc., the Mégane 3 R.S. Ph3 Trophy works on the Nordschleife and other circuits first class! This is also due the RSC Competition Pro. Thus the Mégane makes much more fun and is more and more at home on racetracks. I am very satisfied with the quality and the driving performance that was possible with the RSC Competition Pro, and I will continue to drive diligently and give feedback again with some further changes.

RSC Competition Pro PP997-BB / Porsche 911 / 997

Handmade RSC Suspensions Adjuster

The individual parts:



Aluminium parts anodized:



Pin pressed into the button:



Union nut pushed:



Spring pushed:



Sleeve pressed:



RSC Suspensions sticker attached:



Finished and mounted:

First RSC Suspensions coilover kit for Australia!

RSC Competition Pro Renault Clio 2 V6 Ph1 PCB1A-RSC (RSC Special) silver/darkblue:

RSC Competition Pro Öhlins Upgrade Kit PDZVT-OEH / Renault Mégane 3 R.S installed by GT Entretien France:

RSC Competition Pro Öhlins Upgrade Kit Renault Mégane 3 R.S. Ph3:

Installed at Reno-Tech in Australia:

The RSC Calendar 2018 with the most beautiful moments of the Porsche Supercup season 2017.

- 13 motifs
- A3 format
- High quality print

Price per piece: CHF 35.00

https://www.rscenter.ch/en/products/rsc ... handising/